YWA-10 Wireless Network Adapter Reset Procedure

Last Update: 06/29/2012

Resetting the YWA-10 to factory settings


If you are experiencing difficulty with the setup or the YWA-10 is not responding properly, please reset the unit to the factory settings and start the setup over. 

1.  Make sure that the YWA-10 is powered on. 

2.  Using a paper clip, press and hold down the Reset button on the side of the YWA-10 about    15 seconds until all three lights start to flash On and Off.

         

3.  Release the Reset button.

4.  Please wait 2 to 3 minutes for the unit reset/restart completely.

Note: The wireless light will be blinking when reset/restart is complete.

        Was this answer helpful?

        Thank you for your feedback!

        Thank you for the opportunity to serve you. It is possible that we have another article that will address your issue better.
        Please click here to see additional articles, or click here to contact our tech support team.

        Contact Us

        Do you need an additional help?

        Return to Top