RX-V665 Zone 2 Setup using Extra Speaker terminals

Last Update: 06/27/2013

Untitled Document

Zone 2 Setup on the RX-V665 Using the internal power amp
The RX-V665 extra speaker terminals can power one set of speakers for Zone 2
or Presence speakers. If the extra speaker terminals are utilized then the RX-V665 cannot be set for 7.1 (Surround Back terminals.) or Bi Amp (Surround Back terminals.)

Setting the Extra Speaker Terminals
Note: The RX-V665 remote control will be used to access the Setup Menu of receiver.
1. Press the Setup button on the remote control to enter the Setup Menu.
2. Setup, Speaker Setup will come up on the receiver LED screen.
3. Press the Enter Button on the remote control.
4. Sp Set, 1 Auto Setup will come up on the receiver LED screen.
5. Arrow down until 2 Manual Setup comes up in the receiver LED screen.
6. Press the Enter Button on the remote control.
7. Manual Setup, A)Config will come up on the receiver LED screen.
8. Press the Enter Button on the remote control.
9. SP Set, A)Config will come up on the receiver LED screen.
10. Press the Enter Button on the remote control.
11. Config, Extra………None will come up on the receiver LED screen.
12. Use the Left/Right arrow buttons on the remote to change the Extra
to: Extra……….Zone2.
13. Use the Return and Setup buttons on the remote to exit the setup menu.
14. Extra speaker setup is complete.

To control Zone 2 using the RX-V665 remote the switch at the upper most left hand
corner of the remote must be set to Zone 2. Once the remote has been set to Zone 2
the following commands will be available:

1. Selecting the input source (AV5-6, AUDIO1-2, V-AUX) of Zone 2.
2. Adjusting the volume of Zone2 (when a Zone2 speaker is connected
to the EXTRA SP jack).
3. Tuning into FM or AM when "TUNER" is selected as the input source
of Zone2 (see page 29 of the owner's manual).
4. Tuning into XM Satellite Radio when "XM" is selected as the input
source of Zone2 (see page 31) (U.S.A. model only).
5. Tuning into SIRIUS Satellite Radio when "SIRIUS" is selected as
the input source of Zone2 (see page 35) (U.S.A. model only).
6. Playing back music stored on your iPod stationed in a Yamaha iPod
universal dock (such as YDS-10 sold separately) connected to the DOCK terminal.

Note: Only analog signals can be sent to Zone 2. If you want to output
the sound from Zone 2, connect an external component to AV 5-6 or
Audio 1-2 by analog connection.

Important safety notice:
The EXTRA SP speaker terminals of this unit should not be connected to a
Passive Loudspeaker Selector Box or more than one loudspeaker per
channel. Connection to a Passive Loudspeaker Selector Box or multiple
speakers per channel could create an abnormally low impedance load
resulting in amplifier damage.

Was this answer helpful?

Thank you for your feedback!

Thank you for the opportunity to serve you. It is possible that we have another article that will address your issue better.
Please click here to see additional articles, or click here to contact our tech support team.

Contact Us

Do you need an additional help?

Return to Top