RX-A3050 Firmware Update Instructions

Last Update: 08/20/2015

Untitled Document

Firmware Update

Note: This operation will be performed on the front panel of the unit only.

1. Set the unit to standby mode. (Use the Power button on the front panel of the unit.)

2. While holding down the STRAIGHT button, press the POWER button.

3. ADVANCED SETUP and then SP IMP will show up on the front panel. (Make sure you let go of the Straight button.)

4. Press the PROGRAM ARROW button to the left 2 times to get to UPDATE.......USB.

5. Press the STRAIGHT one time to get to UPDATE........NETWORK.

6. Press the INFO button one time on the unit to start the update.

7. When the update is finished, the receiver will say UPDATE SUCCESSFULL PLEASE POWER OFF.

8. Power the unit back on normally and the update is completed.

 

Was this answer helpful?

Thank you for your feedback!

Thank you for the opportunity to serve you. It is possible that we have another article that will address your issue better.
Please click here to see additional articles, or click here to contact our tech support team.

Contact Us

Do you need an additional help?

Return to Top