P2500S P5000S P7000S - Using Back Panel Filters for Speaker Crossover

Last Update: 12/23/2010

 

For a subwoofer crossover, set the [FILTER] switch to the Subwoofer position. This will give a 12 dB rolloff of high frequencies above the frequency set by the [FREQUENCY] control.

NOTE: This amplifier should be connected only to the subwoofer(s).

 

For a high pass crossover, set the [FILTER] switch to the Low Cut position. This will give a 12 dB rolloff of low frequencies below the frequency set by the [FREQUENCY] control.

NOTE: This amplifier should be connected only to the full range speaker(s).

 

Was this answer helpful?

Thank you for your feedback!

Thank you for the opportunity to serve you. It is possible that we have another article that will address your issue better.
Please click here to see additional articles, or click here to contact our tech support team.

Contact Us

Do you need an additional help?

Return to Top