Installing the Latest Operating System Update (Version 1.03) on an AN200

Last Update: 03/18/2005

Click here to download the Operating System Version 1.03 Update for the AN200. Follow the steps below to install it.

NOTE: If a default media or MIDI player appears when clicking the download link, close the player application and then right-click the download link using the right mouse button. Select 'Save Target As' from the drop-down menu to download the file directly to the desired location.
WARNING: DO NOT touch the PANEL SWITCH or turn off the AN200 while updating.

1) Connect the MIDI OUT of an external sequencer to the MIDI IN of the AN200.

2) Press and hold the [SONG], [SHOW VALUE], and [EXIT] buttons on the AN200, then turn ON the power. The message, 'krnL' will be displayed in the LED screen.

3) Release the buttons, and play back the downloaded file, 'An2_v103.mid' from an external sequencer into the AN200.

4) While updating, the AN200 LED screen will start to count. This will take approximately 12 minutes.

5) When the update is finished, the message, 'Fb0C' will be displayed in the LED screen.

6) Turn the power OFF.

7) Press and hold the [SONG], [PATTERN], and [EXIT] buttons on the AN200, then turn ON the power. The following version messages will be displayed: 'nrML' / '1.030' / 'krnL' / '0.500' / 'PLG' / '1.05'

8) Turn the power OFF.

9) Press and hold the [SHOW VALUE], [PATTERN], and [EXIT] buttons on the AN200, then turn ON the power to execute the Factory Reset. This will take about 20 seconds.

Was this answer helpful?

Thank you for your feedback!

Thank you for the opportunity to serve you. It is possible that we have another article that will address your issue better.
Please click here to see additional articles, or click here to contact our tech support team.

Contact Us

Do you need an additional help?

Return to Top