How to erase only a section that contains a mistake

Last Update: 09/30/2010

Unwanted data can be erased using the song mode Erase Event job. Refer to the procedure described below.

1. Press the [JOB] button to enter the Song Job mode. Press the [F3]:EVENT button, position the cursor at the 03: Erase Event item, and press the [ENTER] button.

2. The Erase Event display will appear, as shown below. Press one of the [1] ~ [16] buttons to select the track that contains the data to be erased.

3. Specify the range of measures to be erased via the 001 : 1 : 000  999 : 1 : 000 parameters in the display, as shown below.


" Position the cursor at the start measure parameter and use the data dial to select 005 : 1 : 000.
" Position the cursor at the end measure parameter and use the data dial to select 017 : 1 : 000.

4. When the measure range has been specified press the [ENTER] button to execute the Erase Event job.

Was this answer helpful?

Thank you for your feedback!

Thank you for the opportunity to serve you. It is possible that we have another article that will address your issue better.
Please click here to see additional articles, or click here to contact our tech support team.

Contact Us

Do you need an additional help?

Return to Top