NOTE: This setting can only be used in VOICE Mode.
NOTE: The A/D Gain setting (far upper left side of the MOX) must be set to the appropriate level for the signal being received and the A/D on/off button must be ON (lit).
1. Press the [UTILITY] button.
2. Press the [F3] button.
3. Press the [SF1] button.
4. Assign LMONO or RMONO to the MONO/ST setting.
NOTE: The setting in step 4 is determined by which A/D input isbeing used (The Left and/or Right located in the back of the MOX).
5. Press the [SF3] button.
6. Assign the first effect to Type.
NOTE: Use the data wheel to select a REVerb, CHOrus, DELAy, or whatever else may be needed.
NOTE: This screen is also used to assign the other parameters for the effect used in step 6.
NOTE: Steps 7 and 8 can be skipped if only one effect is being used.
7. Press the [SF4] button.
8. Assign the second effect to Type.
NOTE: This screen is also used to assign the other parameters for the effect used in step 8.
9. Press the [STORE] button when finished.
Do you need an additional help?