Applying Effects to the A/D Input Signal.

Last Update: 12/05/2012

NOTE: This setting can only be used in VOICE Mode.

NOTE:
The A/D Gain setting (far upper left side of the MOX) must be set to the appropriate level for the signal being received and the A/D on/off button must be ON (lit).


1. Press the [UTILITY] button.


2. Press the [F3] button.


3. Press the [SF1] button.


4. Assign LMONO or RMONO to the MONO/ST setting.


NOTE:
The setting in step 4 is determined by which A/D input isbeing used
(The Left and/or Right located in the back of the MOX).

5. Press the [SF3] button.

6. Assign the first effect to Type.

NOTE:
Use the data wheel to select a REVerb, CHOrus, DELAy, or whatever else may be needed.


NOTE:
This screen is also used to assign the other parameters for the effect used in step 6.


NOTE:
Steps 7 and 8 can be skipped if only one effect is being used.


7. Press the [SF4] button.


8.
Assign the second effect to Type.

NOTE:
This screen is also used to assign the other parameters for the effect used in step 8.


9. Press the [STORE] button when finished.

Was this answer helpful?

Thank you for your feedback!

Thank you for the opportunity to serve you. It is possible that we have another article that will address your issue better.
Please click here to see additional articles, or click here to contact our tech support team.

Contact Us

Do you need an additional help?

Return to Top